块体非晶合金变形过程中结构演化的原位研究-els-cdn.docVIP

Supplemental materials for “Bridging shear transformation zone to the atomic structure of amorphous solids” Meng Zhang, Yun Jiang Wang, and Lan Hong Dai( State Key Laboratory of Nonlinear Mechanics, Institute of Mechanics, Chinese Academy of Sciences, Beijing 100190, China I. Collections of the reported length scale dependent strain of amorphous alloys in literatures Length scale dependent strain of 4 amorphous alloys in tension1: Dashed line indicates the strain measured by extensor meter and the data points are atomic strain measured from peak shifts of radial distribution function (RDF) in the scattering tests. Length scale dependent strain of BMG 2: Zr46.5Cu45Al7Ti1.5 Dashed line indicates the strain measured by extensor meter and the data points are atomic strain measured from peak shifts of radial distribution function (RDF) in the scattering tests. Length scale dependent strain of BMG 3: Zr57Ti5Ni8Al10Cu20 Dashed line indicates the strain measured by extensor meter and the data points are atomic strain measured from peak shifts of radial distribution function (RDF) in the scattering tests. Length scale dependent strain of BMG 4: Zr57Ti5Ni8Al10Cu20 The data points are atomic strain measured from peak shifts of radial distribution function (RDF) in the scattering tests. Length scale dependent strain of BMG 5: Zr62Al8Ni13Cu17 and La62Al14(Cu5/6Ag1/6)14Co5Ni5 The data points are atomic strain measured from peak shifts of radial distribution function (RDF) in the scattering tests. From these reported results, it can be seen that the length scale dependent strain develops with increasing stress level in a length scale of 0~1.6 nm corresponding to the 2~6 shells of atoms on the radial distribution function (RDF) and reflects the anelastic atom rearrangements of different shells as proved in the Ref. 3. This scale of 1~2nm encompasses well the size of the shear transformation zones recognized. II. Energy barrier density of amorphous alloys Table SI. Mechanical