兰州交通大学通风空调毕业设计说明书.doc

摘 要 本设计为兰州三雅康体中心空调系统工程设计，该空调系统为舒适性空调系统。此设计中的建筑主要房间为浴室，大多面积较小，且各房间互不连通，应使所选空调系统能够实现对各个房间的独立控制，综合考虑各方面因素，确定选用风机盘管加新风系统。在房间内布置吊顶的风机盘管，采用暗装的形式。将该集中系统设为风机盘管加独立新风系统，新风机组从室外引入新风处理到室内空气焓值，不承担室内负荷。风机盘管承担室内全部冷负荷及部分的新风湿负荷。 在冷负荷计算的基础上完成主机和风机盘管的选型，并通过风量、水量的计算确定风管路和水管路的规格，并校 关键词：风机盘管加独立新风系统 管路设计 制冷机组 冷水机组 Abstract The design for the Lanzhou Sanya’s recreation center air conditioning systems engineering design, the air-conditioning system for the comfort of air conditioning systems. This design of the main building rooms for bathrooms., most of them is very small, and the rooms are not connected, the selected air-conditioning system should be able to achieve independent control of each room, considering the various factors to determine the selection of fan-coil plus fresh air system. Arrangement in the room ceiling fan coil units, using the dark form of equipment. Set the focus on fan-coil system, plus an independent air system, fresh air from the outdoor unit to deal with the introduction of a new wind to the indoor air enthalpy value, do not bear the load of indoor. All bear the indoor fan-coil cooling load and part of its new rheumatoid load. In the cooling load calculation based on the completion of the selection of host and fan coil units, and air volume, the calculation of water, the wind pipe and water pipes to determine the specifications of the road and check the resistance to the most disadvantaged and the loop to determine the pressure head new fans and pumps. Based on the relevant manuals provided by air-conditioning design parameters, and further completion of the new air units, water pumps, hot water units, such as the selection, which will be reflected in their drawings, the final design of the entire air-conditioning system Through the Graduation Project, studied the use of the basic theory and professional knowledge, combined with engineering practice, according to the relevant norms, standards, engineering design, and other reference atlas and in