滴水灌溉系统——城市园林绿地规划(英).pptxVIP

Drip IrrigationBest to find out what the water pressure is in your building.Fit a pressure gauge to the isolation valve. Pressure should be about 60 to 75 psiBackflow PreventerPrevents dirt, salmonella, etc from being sucked back into drinking water system.ImportantAlways use backflow preventer on every drip systemPressure Regulators and Pressure Reducing ValvesYou will need to install a pressure regulator on your drip system if your water pressure is higher than 2,8 bars (40 PSI). Types of filtersScreen FilterMost CommonCheapExcellent for removing hard particulates from water, such as sandMedia FilterBest for removing organic material from the water?Water Source withSuggested Filter TypesMunicipal Water SystemScreen Filter, Centrifugal Filter, or Disk Filter.WellScreen Filter, Centrifugal Filter, or Disk Filter.River or CreekDisk Filter, Media Filter and Screen Filter, Centrifugal and Media Filter.Pond or LakeDisk Filter, Media Filter and Screen Filter, Centrifugal and Media Filter.Spring or Artesian WellScreen Filter, Centrifugal Filter, or Disk Filter.Organic material in waterDisk Filter, Media Filter and Screen Filter, Centrifugal and Media Filter.Sand in waterScreen Filter, Centrifugal Filter, or Disk Filter.Mainlines Laterals The mainline is the pipe that goes from the water source to the control valves. The lateral is the pipe located between a control valve and the drip tube. Total length of the mainline and the lateral together should not be more than 120 meters (400 feet)Maximum drip tube lengthThe length of drip tube (or drip hose) may not exceed 60 meters (200) from the point the water enters the tube to the end of the tube Thus you could have 120 meters (400) of tube if the water entered the tube in the middle (that would be 60 meters from the point the water enters the tube to the end of the tube in each direction.Zone control ValvesStandard Globe ValveGlove valves are available in just about any size Anti-siphon valve Available only in 20mm (3/4 inc