【精选】on MAC OS X Based Computers..pdfVIP

Freescale Semiconductor Document Number: AN3818 Application Note Rev. 0.0, 02/2009 Running Freescale IEEE™ 802.15.4 Boards on MAC OS X Based Computers 1 Introduction Contents 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . 1 This note describes how to install the USB drivers 2 Installing the Silicon Labs driver for CP210x 2 needed to run Freescale 802.15.4 development boards on 3 Installing the FTDI driver for the FT232x . . . 3 the Mac OS X. The following drivers will be installed: • Install and modify Silicon Labs VCP driver • Install FTDI VCP driver This note and the drivers used are not supported in any way by Freescale Semiconductor. The Freescale Test Tool and the ZigBee Test Client (ZTC) are not supported on Mac OS X. NOTE This note requires an Intel based Mac with minimum Mac OS X version 10.4.10 (Tiger). © Freescale Semiconductor, Inc., 2009. All rights reserved. Installing the Silicon Labs Driver for CP210x 2 Installing the Silicon Labs Driver for CP210x This section describes step-by-step how to install and modify the Silicon labs driver on the MAC to work with the MC1321x-SRB and MC1321x-NCB boards. 1. Start the Mac and use the internet browser to download the Mac OS X driver from the Silicon Labs website: /tgwWebApp/public/web_content/products/ Microcontrollers/USB/en/mcu_vcp.htm 2. Double click on the cardinal-osx-v1_02_2release.img and run the SLAB_USBtoUARTInstaller.app by double clicking on the icon. Figure 1. Running the SLAB_USB Installer 3. Modify the driver info file as follows