勘查技术专业英语04.docVIP

Lesson 4 Moisture Content Test Methods The standard method for determining moisture content of soils is the oven-drying method, and this is the procedure recommended for a soil laboratory. A subsidiary method using a heated sand-bath is also described for use on site where an oven is not available or would be impracticable. Another site method used extensively for moisture control of fill is the carbide provided by the manufacturer with the equipment. 第四课 含水量 试验方法 测定土的含水量的标准方法是烘箱烘干法，这也是土工试验所采用的方法。而在工程现场（site）无烘箱或不现实时，可用热沙浴作为一种辅助方法。另一种广泛应用于控制填土含水量的现场测试法是碳化物法，这种设备和碳化物可由制造厂家提供。（碳化物随设备一起由厂家提供）。 注释: 1.moisture 湿度，湿气。2.oven-drying 烘箱烘干。3.recommended 建议的，推荐的。4.subsidiary 辅助的。5.sand-bath 沙浴。6.site 现场的。7.extensively 广泛地。8.carbide 碳化物。9.manufacture 制造。10.would be impracticable 虚拟语气。 Another method, in which methylated spirit is mixed with the soil and ignited, is given in the British Standard, where it is referred to as the Alcohol Method. This procedure is not recommended as a laboratory method, because of the risk of fire, and is not described here. 另外一种是将土和含甲醇酒精混合点燃法，英国规范已采用，称做酒精法。实验室不采用此种方法（这种方法并不被推荐作为实验室方法），因为有火灾危险，本文不进行介绍。 注释: 1.methylate 加入甲醇。2.spirit 酒精。3.alcohol 酒精。4.ignite 点火。 Oven drying (BS 1377: 1975, Test l (A)) A drying temperature of 105–110℃ is specified as the standard procedure, and this should be used as a general rule. However, this temperature may be too high for certain types of soil. For peats and soils containing organic matter a drying temperature of 60℃ is to be preferred, to prevent oxidation of the organic content. For soils containing gypsum the water of crystallisation may be lost at temperatures above 100℃, so a temperature not exceeding 80℃ should be used. The same can apply to some soils from tropical regions. These lower temperatures may require longer drying time. 烘箱烘干法 （BS1377，1975，实验 1（A））（BS stands for British standard） 烘干温度标准是105–110℃，这应做为一般规定（执行）。但是，此温度对于某些土类可能是太高了。对于泥炭和含有机物的土来说，60℃温度是合适的，它可避免有机物的氧化。对于含有石膏（H2SO4.Ca.2H2O）的土，温度高于100℃时，其