fsl_sata控制器linux驱动实现分析.docx

Author:YY_HongDepartment:EmSwDeptDate：2011-3-10Abstract本文给出了freescale公司的sata控制器的linux驱动实现方式。Analyse the difference between bare board and the board installed linux.Try to address the performance bottbleneck.TextFreescale’s sata controller driver is in the lowest layer of the block driver.below is the figure show up the relation about all layers in block driver:驱动是top-down transmit。对/dev/sdx初始化安装ATA_BASE_SHT#define ATA_BASE_SHT(drv_name)\.module= THIS_MODULE,\.name= drv_name,\.ioctl= ata_scsi_ioctl,\.queuecommand= ata_scsi_queuecmd,\.can_queue= ATA_DEF_QUEUE,\.this_id= ATA_SHT_THIS_ID,\.cmd_per_lun= ATA_SHT_CMD_PER_LUN,\.emulated= ATA_SHT_EMULATED,\.use_clustering= ATA_SHT_USE_CLUSTERING,\.proc_name= drv_name,\.slave_configure= ata_scsi_slave_config,\.slave_destroy= ata_scsi_slave_destroy,\.bios_param= ata_std_bios_param,\.unlock_native_capacity= ata_scsi_unlock_native_capacity, \.sdev_attrs= ata_common_sdev_attrs#define ATA_NCQ_SHT(drv_name)\ATA_BASE_SHT(drv_name),\.change_queue_depth= ata_scsi_change_queue_depthATA_PIO_SHT/* PIO only, sg_tablesize and dma_boundary limits can be removed */#define ATA_PIO_SHT(drv_name) \ ATA_BASE_SHT(drv_name), \ .sg_tablesize = LIBATA_MAX_PRD, \ .dma_boundary = ATA_DMA_BOUNDARYATA_NCQ_SHT#define ATA_NCQ_SHT(drv_name)\ATA_BASE_SHT(drv_name),\.change_queue_depth= ata_scsi_change_queue_depthstruct ata_hoststruct ata_host {spinlock_tlock;struct device *dev;void __iomem * const*iomap;unsigned intn_ports;void*private_data;struct ata_port_operations *ops;unsigned longflags;#ifdef CONFIG_ATA_ACPIacpi_handleacpi_handle;#endifstruct ata_port*simplex_claimed;/* channel owning the DMA */struct ata_port*ports[0];};struct ata_portstruct ata_port {struct Scsi_Host*scsi_host; /* our co-allocated scsi host */struct ata_port_operations *ops;spinlock_t*lock;/* Flags owned by the EH context. Only EH should touch these once the port