毕业论文可回转电动平车设计.docVIP

摘要 电动平车是电动轨道运输车辆，在车间内搬运产品。它具有结构简单、使用方便、容易维护、承载能力大、污染小等特点。普遍用于机械和冶金行业的车间产品运输。本文在大量查阅资料的基础上，在实践中，进行可回转电动平车设计。 在设计时，依据可回转电动平车设计任务书，对电动平车车架、传动系统、行走机构进行设计并分析车轮的性能加以选择。在设计过程中，主要有三个设计重点。第一：车轮的选用。车轮虽然是标件，但车轮的选择为以后的设计工作提供了基础。 首先要确定出车轮的相关参数，特别是车轮的直径。第二： 传动系统的设计。在设计的过程中，一共设计了两种传动系统可以选择，两种传输方案是使用3维建模分析，最后由设计的传动系统安装第二种合理性。第三：行走机构的设计。在这块的设计中，对主动轮轴及从动轮轴进行设计并加以分析校核。 为进一步测试驱动轮轴是不是符合强度要求，采用UG8.0分析主动轮轴。 关键词：电动平车 行走机构 传动系统 回转机构 ABSTRACT Electric-car electric rail transport vehicles, carrying products in the workshop. It has a simple structure, easy to use, easy to maintain, large carrying capacity, little pollution. Drag product widely used transport machinery and metallurgical industries. Based on a large number of access to information, in practice, make may turn electric flat car design。 At design time, according to the rotatable electric-car design task book, for electric-car chassis, transmission, running gear design and analysis of the performance of the wheel to choose. During the design process, there are three main design focus. First: the wheels of choice. While the wheel is standard items, but the wheels of choice provides the basis for future design work. First, to determine the relevant parameters of the wheel, in particular the diameter of the wheel. Second: drive system design. In the design process, the design of a total of two drive systems to choose from, two transmission solution is to use 3-D modeling and analysis, and finally install a second drive system designed by the rationality. Third: walking mechanism design. In this design, to take the initiative and driven axle shaft design and analyze check. To further test the strength of the drive shaft is in line with the requirements analysis using UG8.0 active axle。 Key words: electric vehicles travel agencies Transmission rotating mechanism. 目录 1引言 1 1.1 电动平车的相关概念 1 1.2 电动平车的分类 1 1.3 电动平车的主要技术参数 1 2 电动平车的总体设计 2 3 电动平车车轮的选用 3 3.1 车轮的材料选用 3 3.2 车轮的结构选用