ICEM 圆柱扰流.docVIP

Example on using commercial software Flow around a circular cylinder Y.F.Lin  Two Dimensional problems Flow around a circular cylinder Problem Description Air flows across a cylinder with the uniform velocity 0.003m/s in the wind tunnel. The length of the wind tunnel (fluid domain) has 25m long and 10 m height. The diameter of cylinder is 1m. Assumption and Boundary Conditions: 2 dimensional problems Steady state condition The uniform flow velocity No Heat transfer Neglect the gravitational force Constant air density Pre-processing stage In this stage, we implement the “ICEM CFD” to perform the pre-processing work. The basic steps as follow: Establish geometry model Block the parts Generation the O grid Mesh the model and check quality of mesh Extrude the mesh Reset the BC’s (boundary conditions) Output to CFX5.7.1 Creating Geometry 1. Open ICEM CFD Double Click the “ICEM CFD” Icon, afterwards, you can see the interface of the ICEM CFD. Open FileNew Project…: Set the name with “cylinder_2d”, and Click “Save” 2. Creating Geometry: Points Click button “Create Point” and then click button “Explicit Coordinates” Set the points in Cartesian coordinate system(X, Y, Z) with ( X=0, Y=0, Z=0 ) respectively. Click “Apply” button and see the screen: a point is created A tree widget can be seen at left of the screen (A) and (B) The same method creates other points: X=0; Y=0.5, -0.5 X=-5; Y=5, -5 X=20; Y=5, -5 Y=0; X=0.5,-0.5 Draw line (curve) First of all see the tree widget, open ModelGeo-55metryPoints by right button Select Show Point Names and you can see the name of each point like the figure showed. Now you can create curves Click button “Create/Modify Curve” Click button “Create Curve” Note: the left corner of the black screen: Select locations with left button, middle=done, right=cancel Select points by using left button of the mouse. Change the name of the Part with “INLET”: Select PON