AD7980翻译版.doc

16-Bit, 1 MSPS PulSAR ADC in MSOP/QFN AD7980 FEATURES 16-bit resolution with no missing codes Throughput: 1 MSPS Low power dissipation: 7.0 mW @ 1 MSPS, 70 μW @ 10 kSPS 应用图示例 2.5V TO 5V 2.5V INL: ±0.6 LSB typical, ±1.25 LSB maximum SINAD: 91.25 dB @ 10 kHz THD: ?110 dB @ 10 kHz  0 TO VREF  IN+ IN– REF VDD VIO SDI AD7980 SCK SDO 1.8V TO 5V 3- OR 4-WIRE INTERFACE (SPI, DAISY CHAIN, CS) Pseudo differential analog input range 0 V to VREF with VREF between 2.5 V to 5.5 V Any input range and easy to drive with the ADA4841 No pipeline delay Single-supply 2.5 V operation with 1.8 V/2.5 V/3 V/5 V GND CNV Figure 1. logic interface Serial interface SPI-/QSPI?-/MICROWIRE?-/DSP-compatible Daisy-chain multiple ADCs and busy indicator 10-lead MSOP and 10-lead, 3 mm × 3 mm, QFN (LFCSP), same space as SOT-23 Wide operating temperature range: ?40°C to +125°C APPLICATIONS Battery-powered equipment Communications ATE Data acquisitions Medical instruments 概述 The AD7980 is a 16-bit, successive approximation, analog-to- digital converter (ADC) that operates from a single power supply, VDD. It contains a low power, high speed, 16-bit sampling ADC and a versatile serial interface port. On the CNV rising edge, it samples an analog input IN+ between 0 V to REF with respect to a ground sense IN?. The reference voltage, REF, is applied externally and can be set independent of the supply voltage, VDD. Its power scales linearly with throughput. The SPI-compatible serial interface also features the ability, using the SDI input, to daisy-chain several ADCs on a single, 3-wire bus and provides an optional busy indicator. It is compatible with 1.8 V, 2.5 V, 3 V, or 5 V logic, using the separate supply VIO. The AD7980 is housed in a 10-lead MSOP or a 10-lead QFN (LFCSP) with operation specified from ?40°C to +125°C.  Table 1. MSOP, QFN (LFCSP) 14-/16-/18-Bit PulSAR? ADC Type 100 kSPS 250 kSPS 400 kSPS to 500 kSPS 1000 kSPS ADC Driver 18-Bit 16-Bit 14-Bit AD7680 AD7683 AD7684 AD7