螺杆泵工况诊断(英文).docx

Research on the screw pump working condition diagnosis technologyAbstractThis thesis selects the screw pump as well pumping mode as the object, working condition of ground drive screw pump well as mainly focuses on the various parameters, with the help of Shuguang oil production plant of Liaohe oilfield test, in the normal production data for working condition judgment condition of screw pump pumping well analysis and judgment. First of all, this testing system for screw pump wells hardware devices are studied by the basic realization of correlation function and main technical index. Secondly, establish working condition diagnosis model, ground drive screw pump well，at the same time, study the fault type of sucker rod and tubing for screw pump, and subdivided into 11. Then, the fault diagnosis method respectively from the traditional diagnosis method, characteristic curve control method and the method of synthetical diagnosis were analyzed, ground drive screw pump working condition diagnosis method program diagram, drawing in addition, calculation formula of motor working condition diagnosis and system efficiency of screw pump well established, laid the solid foundation for the daily study and field application. Based on the above research results, research and development of the supporting software of screw pump well. Finally, the screw pump well Shuguang oil production plant of Liaohe Oilfield Company of five representative was analyzed and the effect of field application test, the feasibility and necessity of this study further verified through field test, indicates that the practice value of the research.Key?words: screw pump; working condition diagnosis;rod; efficiency of the system摘要本研究论文选取以螺杆泵作为采油方式的抽油井作为对象，以地面驱动螺杆泵井的工作状况作为研究的主要重点，借助辽河油田曙光采油厂测试的各种参数，以正常生产数据为判断条件对螺杆泵抽油井的工作状况进行分析和判断。首先，本文对螺杆泵采油井的测试系统的硬件设备进行了研究提出了基本实现功能和主要技术指标的相关要求。其次，建立了地面驱动螺杆泵井工况诊断计算模型，同时，对螺杆泵井故障类型分为井下泵故障、抽油杆故障和油管故障，并细分为 11 种。然后，对故障诊断方法分别从传统诊断方法、特征曲线对照法和综合诊断法进行了分析，绘制了地面驱动螺杆泵工况综合诊断法程序框图，另外，对电机工