LCD专业知识教育资料[一].pptVIP

4.2.2 PI工程简介 4.2.3 Rubbing工程、简介 4.2.4 Spacer工程简介 4.2.5 Assembly工程简介 4.2.6 Assembly工程简介 4.2.7 注入工程简介 QC Flow Chart TAB Zone Assembly Zone Module工程： 4.3 Module工程简介 Removing dirty by turning knife Removing dirty by purified water Removing dirty by ultrasonic Cleaning by deionizing water (D.I:Deionizing Water) Drying by hot gas (temp:40~50℃) Panel position Polarizer attachment Removing the dirty on the panel purpose Removing dirty by turning knife 4.3.1 清洗工程简介 Polarizer position Adjust polarize position by camera camera Attach polarize on table Attachment table Attach engineering label by label publish machine label *TCP : Tape Carrier Package TCP attachment Attach polarizers on both panel surface HF4R309A2G purpose Attach lower and upper polarizes on table Attachment table 4.3.2 POL工程简介 Pressing the ACF by hot puncher (temp:80℃, pressure:1Mpas, time: 2Sec) camera New roller Hollow roller panel Hot puncher - temperature: 180℃ - pressure : 3~4Mpas - time : 10~12Sec TCP TCP TAB inspection Attach TCP on the panel by constant temperature puncher purpose Attach TCP completely by high temperature puncher Adjust the panel position by camera and Then attach the ACF Attach the TCP on the panel temporary in lower temp and lower pressure condition Manage the engineering record by BCR(Bar Code Reader) 4.3.3 TAB工程简介 Adjust PCB position on the panel Detect the NG product after removing the label Discriminate the preliminary defect product And good product after inspection *PCB : printing circuit board PCB attachment NG GOOD detect the defect earlier,reduce the cost and avoid defect Flow to next position purpose Put the panel on the fixed PCB during TAB inspection Manage the engineering record by BCR(Bar Code Reader) 4.3.4 TAB检查工程简介 * Dell向LCD专业知识教育资料 1.液晶结构介绍 2.液晶显示光学原理 3.Panel内部结构介绍 4. Process介绍 4.1 Cell Process 4.2 Module Process 生产1Team TAB 1Part 目 录 物态的相变化 一、液晶基本原理 液晶的种类 各种热致型液晶分布的温度范围 1.1 液晶分子结构与特性 1.介电系数ε(dielectric permittivity) 2.折射系数(refractiv