外文翻译-6110型柴油机活塞设计及加工工艺过程设计.docVIP

A diesel engine works 【Abstract】In diesel engine cylinder, the piston part of the cycle in the compressed gases, and in another part of the work cycle of the combustion gas mixture within the cylinder so the piston top surface expansion high pressure (about 116 ~ 120Kgf/cm2)under high temperature (about 569°C) gas role, and the pressure through the piston pin, connecting rod to the crankshaft. Can be seen that the piston is a long time under high temperature and high pressure in continuous reciprocating motion of the load, its load and working conditions were appalling. During the design process of the piston will be designed to ensure long-term stability of the work piston. The design of the work done by a brief introduction as follows:Diesel Engine Piston 180C reasonable processing technology is important, the role of parts and technology program analysis, preparation of rough form and process manufacturing line, through the analysis, comparison, use of the relative concentration of processing programs, and ultimately more reasonable to determine the mechanical line processing. The development process of rough line the main consideration, finishing arrangements, choice of processing methods, centralized and decentralized processes, such as processing the order requirements. Then determine the allowance, process size, after the analysis of the characteristics of the process, select the appropriate processing equipment and technical equipment. Calculated look-up table to determine the next major piston cutting process and the mapping of processes card, the design of the final fixture. Fixture design, it is necessary to take various aspects into account, the strict requirements of the fixture a direct impact on the surface of the workpiece processing position accuracy. Therefore, the machine tool design fixture design is an important task is the processing of one of the most active. During the graduation project in a specially designed positioning accuracy, simple st