A parallel output controller POC设计.docVIP

A parallel output controller (POC) Design (Purpose The purpose of this project is to design and simulate a parallel output controller (POC) which acts an interface between system bus and printer. The Altera’s Maxplus II EDA tool is recommended and provided for simulation. ②Tasks POC is one of the most common I/O modules, namely the parallel output controller. It plays the role of an interface between the computer system bus and the peripheral (such as a printer or other output devices). (The overall connection of the simulated printer and POC expressed in the top module ?Three modules: The counter is data generator which output data to the data bus.The POC coordinate the work between CPU and printer.The printer process data by a fixed speed. ⑤Design description of the simulation input waveforms; ?The input and output: CS: input signal that enable the working of POC; CLK: the clock cycle; RESET:input signal that reset or initialize POC and printer asynchronously; RDY:input signal that is a printer ready message to POC. IRQ: Interrupt signal from POC to CPU. TR:a pulse signal to make the RDY be low-level. DATA:8 bits data signal from CPU to POC. BR:a buffer register receive the data from DATA bus. PD:port from which characters are transferred to the printer; ⑥Simulation results (waveforms record and explanation); ?The explanation of the simulation wave: CS is seted as 1 ,then the chip is selected to work. When RESET=1 and hre comes a postive edge of CLOCK,the whole system resets and begin to work. When the system begin to work,the printer set a ready signal (RDY=1) to indicate that it is ready to receive the a character from the PD(8bit parallel data port)of the POC. When the POC receive the RDY signal ,it set a interrupt signal (IRQ=1)to the CPU and the data in the data bus is inputed to the buffer register (BR) of POC. Then the data in BR is transfered to PD and be processed by printer. After the POC tr