AD9954驱动.docxVIP

;======================================================================;; Author : ADI - CAST;; Date : May 2003;; File : ad9954.asm;; Description : serial control mode. ; we assume that master clock is 27 MHz and multiplied by 10; ADUC832 is used to control ad9954. The core clock is 2.097152MHz;;====================================================================== $MOD832; Use ADuC832 predefined Symbols;define instruction byte for each register.CFR1EQU00HCFR2 EQU 01HASF EQU 02HARR EQU 03HFTW0 EQU 04HPOW0 EQU 05HFTW1 EQU 06HNLSCW EQU 07HPLSCW EQU 08HRSCW0 EQU 07HRSCW1 EQU 08HRSCW2EQU09HRSCW3EQU0AHRAMEQU0BH;======================================================================;DEFINE CONTROL PINS OF ADUC832 FOR THE PURPOSE OF AD9954 CONTROL.;Customers should define the pins according to their design.;If P0 is used as the control port, pull-up resistors should be added to each pin of P0.;======================================================================SCLOCK EQUP2.0SDIEQUP3.3SDOEQUP0.6CSBEQUP3.4RESETEQUP2.3CLKMEQUP2.2PWRDEQUP2.1IORSTEQUP3.5FUDEQUP2.7OSKEQUP2.6PS1EQUP2.5PS0EQUP2.4;======================================================================CSEG; Defines the following as a segment of codeORG 0000H; Load Code at 0JMP MAIN; Jump to MAIN;======================================================================ORG 0003h; (INT0 ISR)CLR CRETI; Return from Interrupt;======================================================================ORG 0070hMAIN:; (main program);======================================================================;initialization;after reset of aduc832, the default status of IO ports are 0xFFH;we should set the status of these ports as we need;======================================================================CLRCLKMCLRSCLOCKCLRPWRDCLRIORSTCLRFUDCLRPS0CLRPS1 CLRRBCLROSKCLRSDO CLRRESETCLRCSB;==================================================