8051 模拟spi读写 AT45DB041.docVIP

8051 模拟spi读写 AT45DB041 /******************************************************************************/ /*正常操作电压为2.7~3.6V，实验中发现当电压超过4.25V后读出的状态字节为9A（正常 */ /*的状态字节值为9D），并且读写数据均不准确，所以应当保证卡片的供电电压不超过 */ /*4.25V。 */ /*SPI规范：Data is always clocked into the device on the rising edge of SCK a-*/ /* nd clocked out of the device on the falling edge of SCK.All instruction-*/ /* s,addresses and data are transferred with the most significant bit(MSB) */ /* first. */ /* 2005-06-02*/ /******************************************************************************/ #pragma optimize(5) #include reg52.h #include string.h #define UCHAR unsigned char #define UINT unsigned int sbit SPI_CS = P2^0; sbit SPI_SCK = P2^2; sbit SPI_SO = P2^3; sbit SPI_SI = P2^4; /////////////////////////////////////////////////////// unsigned char SPI_HostReadByte(void){ unsigned char i,rByte=0; for(i=0;i8;i++){ SPI_SCK=0; SPI_SCK=1; rByte=1; rByte|=SPI_SO; } return rByte; } /////////////////////////////////////////////////////// void SPI_HostWriteByte(unsigned char wByte){ unsigned char i; for(i=0;i8;i++){ if((wBytei)0x80){SPI_SI=1;} else{SPI_SI=0;} SPI_SCK=0; SPI_SCK=1; } } /******************************************************************************/ /*Status Register Format: */ /* */ /* | bit7 | bit6 | bit5 | bit4 | bit3 | bit2 | bit1 | bit0 | */ /* ||||||||| */