51单片机与USB芯片PDIUSBD12接口固件程序.doc

51单片机与USB芯片PDIUSBD12接口固件程序 关键词： USB固件程序 ?? ?????????????????????????????????????? 此函数库可以直接使用PHILIPS的Demo驱动D12TEST 以下只用了端点1进行控制传输，端点2的数据传输自己添加，没有使用DMA功能，为简单的固件程序 /**************************************************************************? ??????????????????? PHILIPS PDIUSBD12 FIRMWARE? ???????????? ??COPYRIGHT (c)?? 2005 BY JJJ.?????????????????????? ??--? ALL RIGHTS RESERVED? --? ?? File Name:?????? D12_USB.h?? Author:????????? Jiang Jian Jun?? Created:???????? 2005/4/3?? Modified:??NO?? Revision: ??1.0? ***************************************************************************/#ifndef __D12_USB_H_REVISION_FIRST__#define __D12_USB_H_REVISION_FIRST__ #include REGX51.Hsbit SUSPEND = P3^5; #define D12_INT_ENDP0OUT??0x0001???//中断寄存器位定义#define D12_INT_ENDP0IN???0x0002#define D12_INT_ENDP1OUT??0x0004#define D12_INT_ENDP1IN???0x0008#define D12_INT_ENDP2OUT??0x0010#define D12_INT_ENDP2IN???0x0020#define D12_INT_BUSRESET??0x0040#define D12_INT_SUSPENDCHANGE?0x0080#define D12_INT_EOT????0x0100 #define D12_SETUPPACKET ?????0x20??//读最后处理状态寄存器的设置信息包0010,0000b#define EP0_PACKET_SIZE ????? ?? 16??//p0最大16byte#define USB_ENDPOINT_DIRECTION_MASK ??0x80??//设备请求类型,传输方向 D7 1000,0000b#define USB_REQUEST_TYPE_MASK ????0x30??//bmRequest的设置#define USB_REQUEST_MASK ?????0x0f#define USB_STANDARD_REQUEST ????0x00??//5,6位的定义#define USB_VENDOR_REQUEST ?????0x20#define USB_DEVICE_DESCRIPTOR_TYPE ???0x01??//描述符类型 设备描述符01h,配置描述符02,接口描述符04,端点描述符05#define USB_CONFIGURATION_DESCRIPTOR_TYPE ?0x02#define CONFIG_DESCRIPTOR_LENGTH ??? 0x002E??//配置描述符总长度 //**************************************************************************//Port And Macros And Structure And Union Definitions#define SWAP(x)?? ((((x) 0x00FF) 8) | (((x) 8) 0x00FF))?//交换高低8位#define MSB(x)??? (((x) 8) 0x00FF)????????//取数据高8位#define LSB(x)??? ((x) 0x00FF)?????????//取数据低8位 typedef union _Event_Flags_???????//定义USB事件标志数据类型{?struct _Bit_Flags_?{??unsigned char Timer?????????????? ?: 1;?//定时器