基于单片机的电子日历工作系统的设计(包含仿真、视频和原理图资料).doc

设计题目：基于单片机的电子日历工作系统的设计 作者： 所在单位：（陕西理工学院机械工程学院机自专业机自班级，陕西 汉中 723000） 指导教师： [摘要] 针对电子仪器仪表的发展趋势以及人们日常生活、工作中对电子日历的需要，设计了一种基于单片机的电子日历工作系统。具体步骤如下： （1）完成了系统总体方案设计与论证。根据任务需要对芯片模块、按键模块、时钟模块、显示模块、温度模块等提出方案论证，最终确定了系统总体方案，绘制了系统框图。 （2）根据总体方案完成了系统硬件的设计。通过所选取的硬件搭建了总体电路图。 （3）根据硬件电路完成了系统软件的开发。其中包括时钟模块、温度模块的设计，并编写了程序。 （4）对设计的结果利用Proteus软件进行功能仿真分析，仿真结果验证了电子日历系统的可行性。 （5）完成了样机的制作，经过实际运行验证，完成了任务要求。 [关键词] 单片机，时钟芯片，温度芯片，仿真 Design of Electronic Calendar Work System Based on MCU （Grade,Class0,Major Mechanical Manufacture and Automation，Mechanical Engineering Dept.，Shaanxi University of Technology，Hanzhong 723003，Shaanxi） Tutor: Abstract In view of the development trend of electronic instruments and the needs of peoples daily life and work, the electronic calendar system based on single chip microcomputer is designed. Specific steps are as follows: (1) the overall scheme design and demonstration of the system has been completed. According to the task of the chip module, key module, clock module, display module, temperature module, and so on, and finally determine the system overall scheme, drawing the system block diagram. (2) the hardware design of the system is completed according to the overall scheme. The overall circuit diagram is constructed through the selected hardware. (3) the system software is developed according to the hardware circuit. Including clock module, temperature module design, and the preparation of the program. (4) the results of the design are analyzed by using Proteus software. The simulation results verify the feasibility of the electronic calendar system. (5) completed the production of the prototype, after the actual operation of the verification, complete the task requirements. Key words Single chip microcomputer, clock chip, temperature chip, simulation 目 录 1 绪论 1 1.1 课题研究的背景 1 1.2课题的研究目的与意义 1 1.3课题解决的主要内容 1 2 系统的方案设计与论证 2 2.1单片机芯片设计与论证 2 方案1：采用51系列单片机作为系统控制器 2 方案2：采用凌阳系列单片机作为系统的控制器 2 2.2按键控制模块设计与论证 2 2.3时钟模块设计与论证 2 方案1