回火温度对E690钢碳化物析出量的影响.PDF

回火温度对E690 钢碳化物析出量的影响 杜晓洁, 何宜柱, 杨磊 ( 徽工业大学材料科学与工程学院, 徽 马鞍山 243002) 摘 要 利用内耗方法并结合显微组织与显微硬度分析 研究了回火温度对高性能海洋平台用E690 钢碳化物析出 量的影响遥 结果表明院在相同的回火时间条件下 回火温度对碳化物的析出量有较大影响 与淬火态试样相比 在550尧 600 和650 回火20 min 后试样中的固溶碳析出量分别为86% 尧90%和94% 经690 保温20 min 回火处理后试样中 的固溶碳析出量达到96%曰回火温度越高碳化物完全析出所用时间越短 适当升高回火温度 可以有效地缩短回火时间遥 关键词 内耗曰 回火温度曰碳化物析出 中图分类号 TG 156.5 文献标识码 A 文章编号 Effect of Tempering Temperature on Carbide Precipitation Mount of E690 Steel 1 1 1 DU Xiaojie , HE Yizhu , YANG Lei (School of Materials Science and Engineering, Anhui University of Technology, Maanshan 243002, China)) Abstract 院The effects of tempering temperature on carbide precipitation mount of E690 steel wsed for high performamce of offshore platform were investigated by means of measuring internal friction combined with hardness analysis and microstructure analysis. The results show that tempering temperature has considerable influence on the mount of carbide precipitation, compared with the quenched sample, the carbide precipitation mount is 86%, 90% and 94% tempered at 550 , 600 and 650 for 20 min. When tempered at 690 for 20 min, the carbide precipitation mount is 96%. The higher the tempering temperature, the shorter the time used carbides precipitate completely. Tempering time can be shorten efficiently through increasing tempering temperature appropriately. Key words 院internal friction; tempering temperature; carbide precipitation