验证过的STC12C5A60S2单片机AD程序.docVIP

验证过的STC12C5A60S2单片机AD程序 * 文件名：AD_CAIYANG.C * 功能：使用AD采集电压显示在LCD * 说明：转自网络，本人验证通过 ****************************************************************************/ #includeSTC12C5A60S2.H #define uint unsigned int #define uchar unsigned char sbit CS=P2^0; //LCD12864串行通信片选 sbit SID=P2^1; //LCD12864串行通信数据口 sbit SCLK=P2^2; //LCD12864串行通信同步时钟信号 sbit PSB=P2^5; //LCD12864并/串选择:H并行 L串行 unsigned int temp1,sh1,ge1,n1,m1; unsigned char ad_result_data[10]; //AD转换高八位 unsigned char ad_result_low2[10]; //AD转换低八位 unsigned char ad_result_total[10]; //AD转换总十位 unsigned char ad_average_result; //AD转换十次的平均值 unsigned char Ain,Vin; unsigned char b,t,R; char tp=0; unsigned char code ma1[6]={0xb5,0xe7,0xd1,0xb9,0xa1,0xc3}; //电压: unsigned char code ma2[]={.}; uchar code disp1[]={提示: 按1 键进入}; uchar code disp2[]={功能选择界面. }; unsigned char code num0[]={0xa3,0xb0}; unsigned char code num1[]={0xa3,0xb1}; unsigned char code num2[]={0xa3,0xb2}; unsigned char code num3[]={0xa3,0xb3}; unsigned char code num4[]={0xa3,0xb4}; unsigned char code num5[]={0xa3,0xb5}; unsigned char code num6[]={0xa3,0xb6}; unsigned char code num7[]={0xa3,0xb7}; unsigned char code num8[]={0xa3,0xb8}; unsigned char code num9[]={0xa3,0xb9}; //-------模块延时程序---------------------------- 1ms void delay1ms(uint delay1ms) //STC11F60XE,22.1184M,延时1ms { uint i,j; for(;delay1ms0;delay1ms--) for(i=0;i7;i++) for(j=0;j210;j++); } void delay(uint delay) //STC11F60XE,22.1184M,延时170us { uint i,j; for(;delay0;delay--) for(i=0;i124;i++); for(j=0;j124;j++); } /******************************************************* AD转换程序 *******************************************************/ void AD_initiate() //初始化函数 { ES=0; TMOD=0x21; //定时计数器方式控制寄存器,自动重装,16位计数器. SCON=0x50; //串行控制寄存器,方便在串口助手那观察 TH1=0xfa; TL1=0xfa; TR1=1; } void ADC_Power_On() //AD转换电 { ADC_CONTR|=0x80; delay(5); //必要的延时 } void get_ad_result() //取AD结果函数,它是十位AD转换，每十次平均，最后取低八位作为AD采样数据 { uint i,q=0; for(i=0;i10;i+