美国深特Xentaur公司.doc

美国深特Xentaur公司 XPDM型便携式露点仪 用 户 手 册 目 录 介绍··························································2 警告··························································2 原理······················································3 操作XPDM··················································4 4.1样气连接·················································4 4．1．1 连接接口··················································4 4．1.2 连接管路················································4 4．1.3采样条件··············································4 4.2 测量过程·····················································4 用户接口··················································5 5．1显示惯例··················································5 5．2状态模式·················································5 5．2.1湿度测量状态···········································6 5．2.2观察传感器温度·········································6 5．2.3自动校准状态模式········································6 5．2.4观察串口数据··········································7 5.3修改参数··················································7 选件···············································7 6.1 RS-232C接口············································7 6.2 电流模拟输出··········································8 6.3 外接电源操作······································8 自动校准············································9 更换干燥剂筒及电池····································9 特殊信息,报警及错误提示································10 附录A: 状态模式下用户操作过程的流程图··························11 附录B: 修改参数状态下用户操作接口的流程图·························11 附录C: 选择lbs, ppmv工程单位时仪器读数与4-20mA输出的关系·············11 附录D: 计算LBS与PPMV时的不确定性·························11 附录E: 电池寿命································11 介绍 XPDM是电池操作的便携式露点仪，由微处理器控制，内置用于传感器干燥的分子筛干燥剂。仪器可用于需要快速测量的所有场合。 标准设备： (带有传感器，干燥剂筒及锂电池的XPDM便携式主仪器。 (用于不锈钢导管安装的2个VCO接口及用于刺软管安装的2个接口 (肩带 选件： ( VCO到VCO安装接口 (灵活的不锈钢软管 (压力调节装置 (凝结过滤器 (墙式变送器（带有工厂安装的I/O选件）。 (可替换的干燥剂筒。 (便携式皮箱。 注意事项 保修权限: 除了工厂培训的专业人员外，其它人不要拆卸XPDM采样槽/活塞件。如果采样槽/活塞件被用户拆卸，则取消保修。 避免污染样气流: XPDM可提供温度低达-100℃露点的快速湿度测量。因此