单片机液晶1602-24C02时钟.docVIP

单片机液晶1602-24C02时钟 #includereg52.h #define uchar unsigned char #define uint unsigned int sbit LCD_RS = P2^6; sbit LCD_RW = P2^5; sbit LCD_EP = P2^7; sbit SDA=P2^1; sbit SCL=P2^0; sbit s1=P3^0; sbit s2=P3^1; sbit s3=P3^2; sbit beep=P1^5; uchar count=0,s1num=0,week=5; int second,minute,hour,year1=20,year2=10,mouth=12,day=25; unsigned char code mouth_0[]={31,28,31,30,31,30,31,31,30,31,30,31}; //设置闰年和非闰年每个月的天数 unsigned char code mouth_1[]={31,29,31,30,31,30,31,31,30,31,30,31}; void delay0() {;;} void delay(uint z) //延时函数 { uint x,y; for(x=z;x0;x--) for(y=110;y0;y--); } void di() { beep=0; delay(100); //扬声器 beep=1; } void start() //24c02开始信号 { SDA=1; delay0(); SCL=1; delay0(); SDA=0; delay0(); } void stop() //24c02停止信号 { SDA=0; delay0(); SCL=1; delay0(); SDA=1; delay0(); } void respons() //应答 { uchar i; SCL=1; delay0(); while((SDA==1)(i250)) i++; SCL=0; delay0(); } void init() //I2c初始化 { SDA=1; delay0(); SCL=1; delay0(); } void write_byte(uchar date) //写一个字节 { uchar i,temp; temp=date; for(i=0;i8;i++) { temp=temp1; SCL=0; delay0(); SDA=CY; delay0(); SCL=1; delay0(); } SCL=0; delay0(); SDA=1; delay0(); } uchar read_byte() //读一个字节 { uchar i,k; SCL=0; delay0(); SDA=1; delay0(); for(i=0;i8;i++) { SCL=1; delay0(); k=(k1)|SDA; SCL=0; delay0(); } return k; } void write_add(uchar address,uchar date) //指定地址写一个字节 { start(); write_byte(0xa0); respons(); write_byte(address); respons(); write_byte(date); respons(); stop(); } uchar read_add(uchar address) //指定地址读一个字节 { uchar date; start(); write_byte(0xa0); respons(); write_byte(address); respon