基于推出试验的型钢混凝土粘结滑移力学分析研究.pdfVIP

第 七 届 全 国 土 木 工 程 研 究 生 学 术 论 坛 东 南 大 学 2009 基于推出试验的型钢混凝土粘结滑移力学分析 殷小溦 （同济大学结构工程与防灾研究所，上海，200092） 摘 要：为了从理论上推导随不同位置变化的型钢混凝土粘结滑移本构关系,本文以推出试验为基础，从型钢与外包混凝土力的 平衡条件入手，推导了出了型钢与混凝土在固定荷载下不同位置处的弹性位移表达式。根据边界条件并采用粘结应力沿型钢锚固 长度呈指数分布的两参数模型，得到了锚固段内任意截面处型钢与混凝土间的相对滑移值及锚固长度的数学表达式。由此得到了 不同位置处型钢混凝土粘结应力与相对滑移的关系式。这些公式可较方便地推广应用到相关有限元分析中。文章最后对计算值与 文献试验值进行了对比，结果证明本文公式有极好的实用性。 关键词：型钢混凝土；推出试验；粘结滑移；本构关系 THEORETICAL ANALYSIS OF PUSH-OUT TEST ON BOND-SLIP CONSTITUTIVE RELATION BETWEEN SHAPED STEEL AND CONCRETE IN SRC STRUCTURES YIN Xiaowei (Tongji University, Shanghai 200092, China) Abstract: In order to theoretically deduce the bond-slip constitutive relation between shaped steel and concrete of different positions in SRC structures, this paper, based on the push-out test, deduced elastic displacements of shaped steel and concrete at different positions under stable load. With the certain boundary condition and the assumption that bond stress is exponentially distributed along the longitudinal length, the relative displacements of shaped steel and concrete at different positions are deduced, as while as the mathematical expression of anchorage length. The relation between bond stress and relative displacement of SRC at different positions was obtained. All of the conclusion mentioned above could be easily applied in the finite element analysis. At the end of this paper, a comparison between the theoretical analysis and the test one was given, and the result agrees very well. Key words: SRC; push-out test; bond-slip; constitutive relation 1 前言 渐大于其界面上的极限抗剪强度，导致构件的粘结破 型钢混凝土推出试验是试件一端混凝土受压，另