基于Moldflow端套成型优化分析.pdf

Mechanical Engineering and Technology 机械工程与技术, 2014, 3, 189-195 Published Online December 2014 in Hans. /journal/met /10.12677/met.2014.34026 Moldflow-Based Molding Optimization Analysis on Pot Head Kai Wang, Chuanyang Wang School of Mechanic and Electronic Engineering, Soochow University, Suzhou Email: suda_wk@163.com st th th Received: Oct. 21 , 2014; revised: Nov. 18 , 2014; accepted: Nov. 27 , 2014 Copyright © 2014 by authors and Hans Publishers Inc. This work is licensed under the Creative Commons Attribution International License (CC BY). /licenses/by/4.0/ Abstract With the rapid development of plastic industry and the wide use of plastic product, the require- ments of mold design are getting much higher. And the traditional mold design method can’t meet current requirements. To improve the quality of plastic products and shorten product develop- ment cycle, more analysis softwares are used to assist the design of plastic mold. In this paper, the best gate location of pot head is analyzed with Moldflow in the molding process. According to the numerical simulation of the main three aspects of the pouring, cooling and warpage, the possible defects of plastic products are predicted. The modified molding process parameters, design pro- grams and other methods are utilized to improve all aspects of the corresponding problems in or- der to optimize the entire plastic molding process. Keywords Pot Head, Moldflow, Injection Molding, Simulation Analysis 基于Moldflow的端套成型优化分析 王 凯，王传洋 苏州大学机电工程学院，苏州 Email: suda_wk@163.com 收稿日期：2014年10月21 日；修回日期：2014年11月18 日；录用日期：2014年11月27 日 189 基于Moldflow 的端套成型优化分析 摘 要 随着塑料工业