Part 14 - Tow Inertia and Seastate Inertia SACST 培.pdf

Part 14 - Inertia Loading 1. Tow Inertia Loading Preparation 1) Under “Training Project”, create “Tow” subdirectory 2) Under “Tow” subdirectory, create “Tow Inertia” directory 3) Copy SACINP.DAT model file from “Gap Loadout” directory to “Tow Inertia” directory. Modifying model for tow inertia load generation Delete load options LDOPT line, load case selection LCSEL line and all load cases and load combinations. Modifying center of roll CENTER line using coordinate X = -35 m, Y = 0.25 m and Z = -3.5 m Create tow input file TOWINP.DAT Tow options need to be set to MN units and center of motion, Coordinate X = -35 m, Y = 0.25 m and Z = -3.5 m Weight group ANOD, LPAD and WKWY are selected using INCWGT line for inertia load generation. Tow input create for 20 degree roll @ 10 seconds period, 10 degree pitch @ 10 seconds period, heave acceleration use 0.2 G. Totally 8 load cases created using MOTION line (or new MOTN line) using “Include effects of Gravity” and “Include Structural Weight” options. +R+H: + Roll + Heave -R+H: - Roll + Heave +R-H: + Roll - Heave -R-H: - Roll - Heave +P+H: + Pitch + Heave -P+H: - Pitch + Heave +P-H: + Pitch - Heave -P-H: - Pitch – Heave The tow input file generated shall looks like following: TOWOPT MNEC OR -35.0 0.25 -3.5XYZ INCWGT ANODLPADWKWY MOTION+R+H 12.5 10.0 0.2 G MOTION-R+H-12.5 10.0 0.2 G Structural Modeling Seminar