球压痕仪机架柔度对硬度的影响分析与标定方法研究-中国测试.PDFVIP

第43卷第11期 中国测试 Vol.43 No.11 2017年 11月 CHINA MEASUREMENT TEST November，2017 doi院10.11857/j.issn.1674-5124.2017.11.007 球压痕仪机架柔度对硬度的影响分析与标定方法研究 金宏平 渊湖北汽车工业学院机械工程学院袁湖北 十堰 442002冤 摘 要院针对Oliver-Pharr法计算压痕硬度的精度受机架柔度影响的问题袁该文将微压痕仪简化为弹簧串联模型袁基 于Oliver-Pharr方法袁建立机架柔度对接触深度和压痕硬度误差影响的解析模型遥 采用有限元仿真分析袁获得压痕功 比值与压痕深度比值之间的函数关系袁建立实际压痕深度与机架柔度无关的压痕参数的解析模型袁实现机架柔度的 标定遥 实验表明院该方法能够快速高效地对机架柔度进行标定遥 关键词院球压痕曰柔度曰标定曰硬度 文献标志码院A 文章编号院1674-5124渊2017冤11-0031-06 Study on the effect analysis and calibration method of machine compliance on hardness for spherical indentation instrument JIN Hongping 渊Department of Mechanical Engineering袁Hubei University of Automotive Technology袁Shiyan 442002袁China冤 Abstract: For the accuracy of the indentation hardness using the Oliver-Pharr method is affected by the frame compliance袁 the micro-indentation instrument was simplified as a spring series model in this paper袁 two analytical models for the influence of frame compliance on contact depth and indentation hardness were establishedbased onthe Oliver-Pharr method. Used finite element simulation method袁 the relationships between the indentation work ratio and indentation depth ratio were obtained袁 an analytical model between the actual indentation depth and the indentation parameters independent of the frame compliancewas established袁 and thenthe frame compliance was calibrated. The results of indentation experiments are shown that the frame compliance can be quickly and efficiently calibrated. Keywords: spherical indentation曰 compliance曰 calibration曰 hardness 0 引 言