串口升级步骤.docVIP

大华NVS串口升级步骤 NVS IP地址和电脑IP地址需在同一网段。设置TFTP文件夹路径“在查看---选项”，需注D系列和C系列不能搞错；设置迷你终端的串口“文件----系统设置----通讯设置”，端口和电脑的端口号一致，波特率为：115200。设置好后点“建立连接” 设置好TFTP和迷你终端后，开启NVS的同时，按三次“*”键 Hit any key to stop autoboot: 1 0 s3c2510 # setenv ipaddr 08 //IP地址为NVS地址 s3c2510 # setenv serverip 00 //IP为电脑的地址 s3c2510 # saveenv //保存 Un-Protected 1 sectors Erasing sector 1 ... Saving environment to flash ... done. Protected 1 sectors s3c2510 # run da //清空存储器中数据 Un-Protect Flash Bank # 1 BootFile [armboot-x.bin.img], Load addr [0x100000] ARP broadcast 1 eth addr: 00:1c:25:b6:53:0a Got good ARP - start TFTP Server ethernet address 00:1c:25:b6:53:0a TFTP from server 00; our IP address is 08 Filename armboot-x.bin.img. Load address: 0x100000 Loading: ################### done Bytes transferred = 97230 (17bce hex) ## Checking Image at 0x100000 ... Header CRC Checking ... OK Image Name: uClinux Image Type: ARM Linux Firmware (gzip compressed) Data Size: 97166 Bytes = 94 kB = 0 MB Load Address: Entry Point: Data CRC Checking ... OK Erasing sector 0 ... Erasing sector 1 ... Erasing sector 2 ... Erasing sector 3 ... Erasing sector 4 ... Erasing sector 5 ... Erasing sector 6 ... Erasing sector 7 ... Erasing sector 8 ... done. Erased 9 sectors. Saving Image to Flash ... done. s3c2510 # Armboot version: 2.4.17 -- Mar 18 2008 //重启NVS Code range : 0- 0x0001c1a0 DRAM Configuration: Bank #0:64 MB Flash: 8 MB *** Using default environment do_saveenv ... Un-Protected 1 sectors Erasing sector 1 ... Saving environment to flash ... done. Protected 1 sectors cp15 register r1: 0xC000107D Instruction Cache is ON cp15 register r1: 0xC000107D Data (writethrough) Cache is ON Write Buffer Control register: 0x0000000C Write Buffer is ON Serial: 000000000000000000 HWADDR0: 00:09:30:28:12:22 DVRID: 0x0005 Chan = 16; Product = 5; Func = 0; Ver = 0 Alarm-mode: V2.0 Hit any key to stop autoboot: 0 s3c2510 # sensetenv ipaddr 08 //重新输入 s3c2