A120报警信息.docVIP

5.01 General Maintenance 普通保养 Warning! Disconnect input power before maintaining. 警告！ 维修之前先断开电源 Visualcheck of torch tip and electrode 注意检查割枪喷嘴与电极 Visually inspect the torch body tip, electrode and shield cup 检查割枪本体、喷嘴,电极和保护罩 Visually inspect the cables and leads. Replace as needed 检查电缆和接头，看是否需要换 Replace all broken parts 更换所有损坏元件 Clean exterior of power supply 清理电源外部 Visually check and Carefully clean the Interior 仔细检查，并清理电源内部 5.02 Maintenance Schedule 保修条例 Daily Operational Checks or Every Six Cutting Hours: 日常操作检查或者机器正常工作6小时检查： 1. Check torch consumable parts, replace if damaged or worn. 检查割枪易损件，如损坏及时更换 2. Check plasma and secondary supply and pres- sure/low.检查等离子气体及保护气体的压力度大小。 3. Purge plasma gas line to remove any moisture build-up. 清洗等离子气体气管线,清除水分 Weekly or Every 30 Cutting Hours: 每周或者工作30小时检查： 1. Check fan for proper operation and adequate air low.运行之前检查风扇，空气是否流通顺畅 2. Inspect torch for any cracks or exposed wires, replace if necessary. 检查任何裂缝或暴露的电线, 看是否需要更换。 3. Inspect input power cable for damage or exposed wires, replace if necessary. 　检查输入功率电缆损坏情况，需要的话请及时更换 Six Months or Every 720 Cutting Hours: 半年平均工作720小时： 1. Check the in-line air ilter(s), clean or replace as Required检查管道空气，及时清理或更换 2. Check cables and hoses for leaks or cracks, replace if necessary. 检查电缆和软管的泄漏或裂纹，需要时请及时更换 3. Check all contactor points for severe arcing or pits, replace if necessary. 检查所有接触点，需要时请及时更换 4. Vacuum dust and dirt out of the entire machine. 清理灰尘和污物出整个机器。 5.03 Common Faults 普通状况（简单故障排除） Problem – Symptom 问题状况 Common Cause 原因 Insuficient Penetration 切割不透 1. Cutting speed too fast. 切割速度太快 2. Torch tilted too much. 割枪过于倾斜 3. Metal too thick. 切割金属太厚 4. Worn torch parts 割枪部件损坏 5. Cutting current too low. 切割电流太低 6.Non - Genuine Thermal Dynamics parts used 没使用原装易损件 7. Incorrect gas pressure 错误的气体压力 Main Arc Extinguishes主要的电弧熄灭, 1. Cutting speed too slow. 切割速度太慢 2. Torch standoff too high from workpiece. 割枪距工件太高 3. Cutting c