[计算机]普通表客户按键说明en.docVIP

Key System Manual Key“SET” Enter key. Press the key to return to the up menu while submenu setting status. Key “→” Cursor shift right key Key “↑” Cursor shift up key. Increase the value of flickering byte while data setting status Key “↙” Confirm key The table below shows the code, menu and other parameters of the key function: Key Function Function illuminate Settable content Remark 0.Lo Lowest Input value 0 *（without a dot） 1.Hi Full Input value 5000 *（without a dot） 2.dot Dot position setting 0 to 3 decimals 3.Unt Unit setting “0-N” No unit * “1-t” Unit K “2-A” Unit M 4.Adr Communication address 1-255 1-255 (settable) 5.bAU Baudrate “4800” 4800bit/s “9600” 9600bit/s “1.92E” 19200bit/s 6.o-P Transmit output OP1 Transmit group 1 Transmit corresponding-input selecting SEL L1~L3 First ~ third input channels Other groups ditto * 7.ALA Alarm output AL1 Alarm group1 Alarm corresponding-input selecting SEL L1~L3 First ~ third input channels High or low alarm setting SEt “HI” High alarm “Lo” Low alarm Alarm point setting dAtA 0-9999 Settable data Dead area value d-b 0-9999 Settable data Action delay（s） A.dLy 0-999 Settable data Other groups ditto * 8.FUN Special function Hold 9.SAV Save “NO” Not save “YES” Save current operations * For different requests of the clients，the menu of the meter your bought will exist a little difference. Some of the setting functions wouldn’t be settable or hided in different types of meter ordered by clients. All of these items have been marked a “*” in remarks. * Lowest input setting is invalidated in single function meter (Validated situation: DC input such as 4-20mA. And another example is frequence meter with LED bar display to indicate the range of the LED bar).* DC meters don’t start measure from zero because their input-signal is 4-20mA, 4-12-20mA, 1-5V, 1-3-5V and so on. If there is no signal input, the meter will display a “Loin” to show an open stat