C8051F000,001,002,005,006,010,011,012,015,016,F017的ADC模块的应用。.pdf

AN118 IMPROVING ADC R ESOLUTION BY O VERSAMPLING AND AVERAGING Relevant Devices ments by oversampling and averaging. Addition- ally, more in-depth analysis of ADC noise, types of This application note applies to the following devices: ADC noise optimal for oversampling techniques, C8051F000, C8051F001, C8051F002, C8051F005, and example code utilizing oversampling and aver- C8051F006, C8051F010, C8051F011, C8051F012, aging is provided in appendices A, B, and C C8051F015, C8051F016, and C8051F017. respectively at the end of this document. Introduction Key Points Many applications require measurements using an • Oversampling and averaging can be used to analog-to-digital converter (ADC). Such applica- increase measurement resolution, eliminating tions will have resolution requirements based in the the need to resort to expensive, off-chip ADC’s. signal’s dynamic range, the smallest change in a • Oversampling and averaging will improve the parameter that must be measured, and the signal-to- SNR and measurement resolution at the cost of noise ratio (SNR). For this reason, many systems increased CPU utilization and reduced through- emp