[数学]轮系作业.ppt

Ex.6-13：(1) ZV1不要圆整 (2) da?d1+2ha*m (3) hf=1.2m ?1.2 ?1.25m (4) Ex.7-1 Shown below is a hoist. The teeth numbers of all the gears are: Z1=20, Z2=50, Z2’=15, Z3=30, Z3’=1, Z4=40, Z4’=18, Z5=52. Find the train ratio i15 and point out the rotating direction of the handle to raise the weight. Ex.7-2 Shown below is the gear train in a clock. S, M and H denote the pointers of second, minute and hour, respectively. The given numbers of teeth are Z1=Z2’=8, Z2=64, Z3’=12, Z4’=15. If the modules of gear 4 and gear 5 are equal, find the numbers of teeth Z3, Z4, and Z5. Ex.7-3 Shown below is a gear train in which gear 3 engages with gears 2 and 4 simultaneously. What kind of gear train is it? If Z1=34, Z2=Z3=20, and Z4=74, find the train ratio i1H. 常见错误： 错将此行星轮系当成复合轮系 Ex.7-4 Shown below is a differential gear train with Z1=15, Z2=25, Z2’=20, Z3=60, n1=200 r/min, n3=50 r/min. Find both the magnitude and the direction of nH when (1)?n1 and n3 are in the same direction;(2) n1 and n3 are in the opposite directions. (1)?n1 and n3 are in the same direction (1)?n1 and n3 are in opposite directions 错误：当n1与n3同向时， 当n1与n3反向时， Ex.7-5 In the combined gear train shown below, Z1=36, Z2=60, Z2’=23, Z3=49, Z3’=69, Z4=31, Z5=131, Z6=94, Z7=36, Z8=167, n1=3549 r/min. Find both the magnitude and the direction of nH. 定轴轮系，串联行星轮系，再串联行星轮系 Ex.7-6 In the combined gear train shown below, Z1=20, Z2=25, Z3=15, Z1’=30, Z4=70, Z4’=60, nH=110 r/min. Find both the magnitude and the direction of n1. 用定轴轮系去约束差动轮系。 Ex.7-7 In the combined gear train shown below, Z1= Z5= Z6=17, Z2=18, Z2’=27, Z3=34, Z4=51. n1=110 r/min. Find both the magnitude and the direction of n6. 用行星轮系去约束差动轮系。 常见错误： 两个基本周转轮系的系杆是不一样的。共用同一代号H引起混淆。 常见错误： Ex.7-8 Shown below is a gear train with Z1=16, Z2= Z2’ =25, Z3=57, Z4=56. Find the train ratio i14. They are two planetary gear trains in series (串联). 常见错误：1、齿数比前面的正负号。 7-8. Shown in Fig.7-18 is the gear train in a clock. S, M and H denote the p