DescribingRoutingBetweenVLANs幻灯片.pptVIP

Cisco Network Academy. All rights reserved.. CCNP+ BSMSN v3.0 Cisco Network Academy. All rights reserved.. CCNP+ BSMSN v3.0 Implementing Inter-VLAN Routing Describing Routing Between VLANs Inter-VLAN Routing with External Router Single trunk link carries traffic for multiple VLANs to and from router. Inter-VLAN Routing External Router Configuration Commands Configure on subinterface encapsulation dot1Q (or isl) 10 ip address 10.10.1.1 255.255.255.0 Verify show vlan 10 show ip route Inter-VLAN Routing on External Router: 802.1Q Trunk Link Inter-VLAN Routing on External Router: ISL Trunk Link Verifying Inter-VLAN Routing The ping command tests connectivity to remote hosts. Verifying the Inter-VLAN Routing Configuration Router#show ip interface brief Displays the current IP configuration per VLAN Router#show ip route Displays IP route table information Router#show vlan Displays IP address on interfaces and current state of interface Explaining Multilayer Switching Layer 2 Switch Forwarding Process Logical Packet Flow for a Multilayer Switch Summary A router on a stick can be used to route between VLANs using either ISL or 802.1Q as the trunking protocol. A router on a stick requires subinterfaces, one for each VLAN. Verify inter-VLAN routing by generating IP packets between two subnets. Multilayer switches can forward traffic at both Layer 2 and Layer 3. Multilayer switches rewrite the Layer 2 and Layer 3 header using tables held in hardware. Purpose: This slide discusses the solution of ISL. Emphasize: The Inter-Switch Link (ISL) protocol is used to inter-connect two VLAN-capable Fast Ethernet devices, such as the Catalyst 5000 or