毕业设计论文齐齐哈尔机床厂四工位组合机床控制系统设计.doc

本科毕业设计(论文) 题　　目：齐齐哈尔机床厂四工位 组合机床控制系统设计 学　　院：信息工程学院 专　　业：自动化 学　　号： 学生姓名： 指导教师： 二○○九 年 五 月 二十 日 齐齐哈尔机床厂四工位组合机床控制系统设计 摘 要 本论文设计的组合机床是由通用部件组合而成,其控制系统是采用电气、液压、机械组合的控制方式.在此我主要是针对该控制系统的电气控制电路进行设计，机械、液压控制系统仅作基本说明. 本论文设计的控制系统在硬件设计方面，首先确定电力拖动方案与电动机选择，然后确定继电-接触器控制系统设计方案，最后对主电路，变压器，控制电路等进行设计，同时控制系统的核心控制由德国的西门子（SIEMENS）公司可编程控制器SIMATIC S7-200的专用编程软件STEP 7-Micro/WIN V3.1对程序进行编写、调试、写入. 本论文对四工位组合机床和编程控制器SIMATIC S7-200模块、功能、使用方法和编程软件STEP 7-Micro/WIN V3.2的使用方法.详细阐述了组合机床控制系统的设计，其中包括设计思想及步骤硬件设计部分、软件设计部分、元件选型等. 关键字：四工位组合机床、机械控制、电气控制、可编程控制器（PLC） Qiqihaer Machine Tool Plant Four-Machine Control System Design Chen Cheng Abstract In this paper, a combination of machine tool design is a combination of common components, the control system is the use of electrical, hydraulic, mechanical control portfolio. I was mainly in the control system for electrical control circuit design, mechanical, hydraulic control system for a basic description only.  In this paper, the design of the control system in hardware design, first of all to identify with the electric drive motor options, and then determine the relay - contactor control system design, the last of the main circuit, transformers, control circuit design, etc. At the same time, control system the core of the control of Siemens from Germany SIEMENSs S7 Series Programmable Logic Controller (PLC) to complete.  In software design using the old design to new and innovative design ladder diagram (Chart menu), the use of SIMATIC S7-200 special programming software STEP 7-Micro/WIN V3.1 on the procedures to prepare, debug, write. In this paper, the four-station modular machine tool and programming controller (PLC) to introduce basic knowledge of the specific implications of this thesis SIMATIC S7-200 modules, functions, use of methods and programming software STEP 7-Micro/WIN V3.2. Combination of detailed design of machine control systems, including design concepts and hardware design steps of the part of software design, component select