ABB 800A DCS 培训 Control Builder Training Material.ppt

Objective To teach you how to use Control Builder to program 61131-3 and Control Modules This means that the focus is on the Control Builder functionality and benefits rather than on how to program 61131-3 Agenda Day 1 - Monday 9-10 Industrial IT Overview including all products 10-12 Control IT Hardware AC800C and AC800M incl redundancy 12-13 Lunch 13-14 Control Builder - Hardware Setup 14-15.30 Control Builder - Structure Text Programming 15.30- 17.00 Control Builder - Function Block Diagrams Agenda Day 2 - Tuesday 9-10 Control Builder - Ladder Logic 10-11 Control Builder - Instruction List 11-12 Control Builder - SFC 12-13 Lunch 13-14.30 Control Builder - Function Block Types 14.30-15.30 PID Loop Setup Function Blocks Control Modules 15.30-16.30 Process Panel Engineering 16.30-17 Integrated Engineering with Process Portal (Demo) First time startup of controller Upgrading the Firmware You need to match the firmware of your controller with you version of the Control Builder Connect to controller and PC with the programming cable to the controller (COM4 for AC800M and COM0 for AC800C) Start Serial Firmware Upgrade Press Connect and then hold the reset button on the controller until the R lamp flashed Press Upgrade and wait until you get a completed message Setting the IP Number – Check the PC IP number Your IP number of your controller needs to match the IP number of your control Check the IP number of your PC by using the Command Prompt and the ipconfig command Setting the IP Number - Set IP Number of the Controller Start the IPConfig Tool In the Control Builder Menu Make sure Settings/Com Port matches your port that you have connected the serial cable to Press Connect and then reset on the Controller Change to Advance Mode in order to be able to set your IP number freely and to set the Subnetmask Type in the IP number for the Controller Control Builder Layout Control Builder Layout Control Builder Structure Information Pane Description Show description of se