光学框架测试报告ENISO12870TESTREPORT.doc

Page  PAGE 3 of  NUMPAGES 3 测试报告 TEST REPORT 申请单位： Applicant 收件日期： Date(s) Submitted Date : Report No. : M-TS- Issue : 1.0 样品信息 Sample Information订单号 P.O.客号 Customer型号 Model规格 Size镜框颜色 Frame Color数量 Quantity       测试说明 Test Specification测试环境 Test of Condition标准要求 Standard Requirement测试时间 Test Date ℃； %R.H.EN ISO 12870-2012本次测试项目 Test Items测试结果 Test Result检 测 员： Tested by 核 检 员： Checked by  4.2.1 Construction RequirementPassFailAreas of the spectacle frame should be smooth, without sharp protuberances, and all edges should be rounded. 4.2.3 Nickel Release(Quantitative Analysis) Sample ID Test PartNickel Release(μg/cm2/week)Pass Fail 1 2 3 Specification＜0.5Note: By Inductively Coupled Argon Plasma Spectrometry. 4.2.3 Nickel Release(Qualitative Analysis) Sample ID Test PartPass Fail 1 2 3 SpecificationCEN/CR 12471:2002 4.4 Dimensional Tolerances on Nominal Size Sample ID Horizontal Boxed Lens Size (mm)Distance Between Lenses (mm)Overall Length of Side (mm)Pass Fail 1 2 3 Specification±0.5±0.5±2.0Note: ByTracer LT-1000. 4.6 Dimensional Stability at Elevated Temperature Sample ID l0 (mm)l1 (mm)l1 -l0 (mm)Pass Fail 1 2 3 SpecificationSpectacle Frames: -12≤l1 -l0≤+6 Small Spectacle Frames:-10≤l1 -l0≤+5 4.7 Resistance to Perspiration Sample IDAfter testing for 8hAfter testing for a Total of 24hPass Fail 123SpecificationNo spotting or colour changeNo corrosion, surface degradation or separation 4.8.1 Bridge Deformation Sample ID X (mm)f=(x÷c)×100% (%)Pass Fail 1 2 3 Specification≤0.02c≤2 4.8.2 Lens Retention Characteristics RequirementPassFailTest lens shall be no dislodged wholly or partially from its original location in the groove or mount. 4.8.3 Endur