制鞋业流程之 成型.pdfVIP

鞋面与大底成型 ASSEMBLE UPPERO/S 依照鞋子结构的不同, 通常分车中底与结帮 两种成型流程: According to the different shoe construction, there are two kinds of assembly procedure ,strobel lasting. 结帮流程又分为一次流程及两次流程或多次 流程. For the lasting construction, there are 3kinds of procedure ,one time lasting two times lasting or more than two time lasting. 这里仅以一次结帮流程为例,了解成型的过 程 : Here only show the one time lasting procedure for example to know the assembly procedure: 1. 浸 康 特 SOAK TR COUNTER 1,浸康特时注意康特角不要浸胶。 Pay more attention to the bottom of TR counter can’t be soaked. 用镊子夹住康特放入 药水中 只要除康特脚外其他部分 2 ﹐ 513 , 有碰到胶水 就马上取出来 浸胶不宜过久 过久会使康特软化 , . ﹐ 。 Clip the counter with forceps and then put it into 513 primer . Don’t soak counter too long to avoid the counter from soften. 康特浸好后需放在铁纲滴干。 3 ﹐ Put the counter on the iron shelf after soaking. 4 ﹐康特摆放铁架上凉干时不宜过久,不要超过15分钟。 Make the counter dry not more than 15 minutes. 5.操作员应戴上手套及口罩等环保用品. The operator should wear the safe things of glove respirator. Applied Tooling: 铁网 铁架 手套 镊子 forceps Iron meshwork Iron shelf Glove 2.准备放鞋面 PREPARE UPPER 1,从装鞋面的车架上取下鞋面,贴上流水标以便配双作业,剪断 联机,放鞋面入流水带上. Take the upper from the shelf and attach pair number sticker, then snip the thread that make one pair of upper together, at last put upper on conveyer belt. 2,剪线时不要剪到鞋面. Don’t break the upper when snip thread. 3.注意鞋面要配双. Note: Need make the upper pair. Applied Tooling: 剪刀 scissor 3.楦头底刷白胶 CEMENT LAST BOTTOM WITH LATEX 取一小块泡棉 对折好再夹在夹子上 刷胶时将泡棉在胶水 1. ,