冷却水系统的预膜作业.pptx

Procedure for Pretreatment of Cooling Water;Why should we take the pretreatment of cooling water system? What can we benefit from the pretreatment?;Manual cleaning System flush;What is the step aim to?;Flush flow diagram;Flushing; Chemical addition Monitoring operation Waste exchange;Chemical cleaning;Chemical cleaning;1. Add the chemicals showed in the table above into the system. 2. Keep flushing 24 hours; 3. Stop the recirculation and bleed all the dirty water, including basin; 4. Feed the fresh water into the system; 5. Start up the pump and check the turbidity and the total iron concentration in the cooling water; 6. If the cooling water turbidity lower than 10 NTU and total Iron concentration lower than 0.5 ppm, then get to the pretreatment as step passivation. 7. If the cooling water is dirty, keep pump running about 2-4 hours and blow down the system, and then repeat the steps from 8-10.;1. Passivation 2. High dosage treatment;Chemical;Passivation: Step;Passivation: Monitoring;Passivation: Complete Indicant;Stage ;Q A