[工程科技]选煤厂毕业设计.doc

摘要 本设计由1.8Mt/a选煤厂常规设计和专题论文两部分内容组成。 常规设计是根据生产大样分析，可知原煤为极难选煤，因此采用重介选选煤方法，并制定了重介----浮选联合的工艺流程。同时，为了更好地回收和净化介质，对介质量、水量和数质量分别进行了平衡计算。并编制了最终产品平衡表。 此外，根据选煤厂投产后达到设计所要求的生产指标，进行了设备选型和计算。根据所选设备和制定的工艺流程，进行了车间工艺布置和总平面布置，并进行了经济概算，使得所设计的选煤厂具备新工艺、新设备和新的管理理念。《新兴选煤厂降低介质消耗探讨》关键字：选煤厂 重介-浮选联合 重介质旋流器 工艺流程 Abstract This design from 1.8 Mt / a conventional coal preparation plant design and thematic content of the two papers. Conventional design is based on the kind of production; coal preparation is very difficult to know for coal, therefore re-election by coal preparation methods and to develop a joint dense media and flotation floation. At the same time, in order to better recovery and purification media, referred to the quality, water quality and several were conducted balance calculation. And the preparation of the final product balance. In addition, under the coal preparation plant put into operation after a request by the design of the production indicators, the selection of equipment and computing. According to the selected equipment and the development of the process, a workshop of layout and general layout, and the economic budget, designed to make preparation plant with new technology, new equipment and new management ideas This paper tells about discussion on reducing the medium consumption in the xin-xing coal preparation plant, according to xin-xing coal preparation plant medium actual consumption, medium quality, from referral equipment, technology links oneby one to do the analysis, corresponding to the lower-consumption method. Keyword: Coal preparation plant; Dense media and flotation floation process; Dedium medium cyclone; Process 目录 摘要 I Abstract II 第1章 绪论 1 1.1 选题意义 1 1.2 选题目的 1 1.3 地理位置及自然状况 1 1.3.1矿区位置 1 1.3.2地理概况 1 1.3.3气象与地震 1 1.4 供水供电情况 2 1.4.1 供水情况 2 1.4.2供电情况 2 1.5 设计能力与工作制度 2 1.5.1选煤厂工作制度 2 1.6 产品 2 1.6.1产品 2 第2章 煤质资料的审查与分析 3 2.1 煤质资料的审查分析 3 2.1.1煤质资料的审查 3 2.1.2煤质资料的分析 3 2.2 原煤煤的可选性及可浮性 4 2.2.1原煤可选性 4 2.2.2煤泥可浮性 5 第3章 选煤工艺 6 3.1 选煤方法的确定 6 3.2