机械工程英语翻译课件.pptVIP

However, if the cutting fluid is to be effective, it must reach the chip tool interface. But it is not easy to visualize how it is accomplished in the case of a continuous turning with a single point turning tool, specially when the chip-tool contact pressure is as high as 70 MPa. 可是，如果要使切削液起作用就必须让它到达切屑刀具接触界面。但如何在采用单尖刀具连续车削的场合尤其是切屑-刀具接触压力高达70MPa时实现并非易事。 * Merchant thought that minute asperities existed at the chip-tool interface and the fluid was drawn into the interface by the capillary action of the interlocking network of these surface asperities. Merchant认为：在切屑与刀具接触界面上存在微小的粗粒，切削液通过这些表面的微