英钛股份有限公司.docVIP

ITK OSCILLATORS APPROVAL SHEET Customer: Customer P/N : ITK P/N: Model Name: Date: APPROVED CHECKED PREPARED APPROVED BY: 英鈦股份有限公司 LC Interlink Inc. B1, No. 477, Min-Shui Rd., Taipei, Taiwan 104台北市明水路477號B1 Tel: 02-2532-6955 Fax: 02-2532-6958 =================================== ITK 英鈦股份有限公司 LC Interlink Inc. B1, No. 477, Min-Shui Rd., Taipei, Taiwan, R.O.C.Tel: 02-2532-6955 Fax: 02-2532-6958 1. General 1-1. Description Seam Sealed SMD AT Cut Crystal Oscillators 1-2. Holder Type ITK-705S 1-3. Dimensions Drawing No. 2. Frequency 2-1. Nominal Frequency 22.00000 MHz 2-2. Mode 2-3. Frequency Stability (inclusive of tolerance at 25℃ and operating Temperature Range, voltage and load change, aging, etc.) 25 ppm Max 3. Electrical Specifications 3-1. Test Circuit PRA 1020A 3-2. Output Load Capacitance 15 pF 3-3. Supply Voltage(VDD) 3.3V +/- 10% 3-4. Input Current (Icc) 12mA Max 3-5. Rise Fall Time (Tr / Tf) 10ns Max 3-6. Symmetry 40/60% Max (1-2 VDD) ITK 英鈦股份有限公司 LC Interlink Inc. B1, No. 477, Min-Shui Rd., Taipei, Taiwan, R.O.C.Tel: 02-2532-6955 Fax: 02-2532-6958 4. Environmental Conditions 4-1. Operating Temperature Range -20℃ ~ 70℃ 4-2. Storage Temperature Range -40℃ ~ 85℃ 4-3. Aging Rate +/- 3 ppm / year 4-4. Mechanical Shock Withstand a drop from a height of 75cm onto hard wooden board at least three times. 4-5. Vibration Test 10 ~ 55 Hz, Amplitude 1.5mm sine wave, 3 directions each 2 hours 4-6. Reflow Condition 260℃ / 10sec Max It is recommended to solder at less than 260℃ for 10 seconds or less by hand and to mount it at less than 230℃ for 20 seconds or less by reflow. An example of the infrared ray reflow temperature profile is shown as below ITK 英鈦股份有限公司 LC Interlink Inc. B1, No. 477, Min-Shui Rd., Taipei, Taiwan, R.O.C.Tel: 02-2532-6955 Fax: 02-2532-6958 5. Dimens