吹模的拆卸及安装.docVIP

PROCEDURE REMOVAL – INSTALLATION OF BLOWING MOLD 吹模的拆卸及安装步骤 Close the mold cooling water inlet gates (figure 1)关闭吹模冷却水进水阀门（图1）。 2- Connect to the fittings some appropriate hoses for the discharge of the cooling water.(figure 1)连接相应的水管，把冷却水排出。（图1） Figure 1 Figure 2 NOTE: position some recipients of suitable capacity for the collection of the cooling water 注意：放好合适的集水容器来收集冷却水。 3- Emptying of the mold water.放空模具里的冷却水。 4- Disassembly of water hoses (figure 2, 3拆下冷却水管（图2，3）) Figure 3 * NOTE: for the circuits of hot water or of oil, proceed in the same manner as for the cooling. Close the respective gate valves and empty the mold blowing air in the end of one of the pipes 注意.：对于热水或油管路，和冷却水管路一样，关掉相应的阀门，最后用气把管内吹空。 5- Move the bottle aligner out of position.(figure 4,5) 把aligner 移开（图4，5） Figure 4 Figure 5 6- Disassemble the aligner bracket.(figure 4,5) 拆下aligner 的托架（图4，5）) 7- Disassemble bottles limit switch (figure 6) 拆下瓶子的限位开关（图6）r Figura 6 8- Disassemble mold bottoms (figure 7,8)拆下底模（图7，8） Figure 7 Figure 8 9- Disassemble press center screws, two at the inside and two at the outside of the machine. (figure 9 external screws) 拆下吹模中间位置的螺栓，两个螺栓在机器内侧，另外两个在机器外侧（图9为两个在外侧的螺栓）