设备及管路安装方法英文翻译.docVIP

Table of Content 1. Main facilities in the plant 2 2. The requirements before equipment installation 2 3. Construction preparation 2 4. Installation procedure 3 5. Equipment unpacking test 3 6. The main facilities installation method 4 6.1 Inlet pump installation 4 6.2 Coarse and fine screen installation 5 6.3 Screw conveyor 5 6.4 Grit and grease scrapers installation 7 6.5 The Roots blower installation 8 6.6 The aeration diffusion system Installation 9 6.7 Primary and secondary sedimentation half bridge mud scrapers installation 10 6.8 Submersible mixers installation 12 6.9 Electromagnetic flowmeter installation 13 6.10 The chlorination system Installation 13 6.11 Pumps installation 15 6.12 Pipes and auxiliaries installation 16  Main facilities in the plant There are a variety of facilities in the plant. Here offers the initial introduction to installation of major equipment. The plant includes the facilities on the list: a. Inlet pump b. Coarse and fine screen c. Screw conveyor d. Containers e. Press f. Aeration blowers g. Grit and grease scrapers h. Grit washer i. Ventilator j. Half bridge scrapers k. Submersible mixers l. Gravity belt thickeners m. Thermal power of heat exchanger unit n. Belt filter press o. Electromagnetic flowmeter p. Pumps q. Pipes and auxiliaries The requirements before equipment installation 1. Equipment base, equipment, plant (including glass doors and windows, lighting, etc.) be completed and the assembly is complete, embedded parts in the correct position; 2. Equipment transport routes open and to reinforce the plant at the entrance channel has been set aside by the maximum size of equipment; 3. Equipment to install temporary water, electricity and gas have been sent to the device edge, facilitating the construction use. Construction preparation 1. Equipment, all technical data, drawings, manuals, product certification, all kinds of test records, procedures, norms, standards and related technical documentation required to prepare comp