特高频方法用于套管局部放电检测的可行性研究_肖天为.pdfVIP

第39 卷 第6 期 电 网 技 术 Vol. 39 No. 6 2015 年6 月 Power System Technology Jun. 2015 文章编号：1000-3673 （2015 ）06-1719-06 中图分类号：TM 835 文献标志码：A 学科代码：470·4017 特高频方法用于套管局部放电检测的可行性研究 1 2 1 2 1 2 2 肖天为 ，张强 ，黄炎光 ，印海洋 ，王勇 ，郑书生 ，李成榕 （1．广州供电局有限公司，广东省 广州市 510620 ； 2．华北电力大学 电气与电子工程学院，北京市 昌平区 102206 ） Experimental Research on Partial Discharge Location for Bushings Using UHF Method 1 2 1 2 XIAO Tianwei , ZHANG Qiang , HUANG Yanguang , YIN Haiyang , 1 2 2 WANG Yong , ZHENG Shusheng , LI Chengrong (1. Guangzhou Power Supply Bureau Co. Ltd, Guangzhou 510620, Guangdong Province, China; 2. School of Electrical and Electronic Engineering, North China Electric Power University, Changping District, Beijing 102206, China) ABSTRACT: It is bushing faults that cause most of 关键词：套管；局部放电；定位；特高频 transformer unplanned outages. Until now, preventive test DOI ：10.13335/j.1000-3673.pst.2015.06.040 methods are widely used for estimating the insulation condition 0 引言 of bushings. Since the preventive test cycle is too long, it is difficult to find out latent defects effectively. In this paper, 变压器出线套管结构紧凑，由于设计缺陷、安 on-line partial discharge (PD) detection method and a TDOA 装不当、外部环境因素等原因产生局部放电，并不 location method based on ultra-high frequency (UHF) signals 断发展，最终导致套管炸裂、变压器停运等严重后 are presented. Firstly, the fundamental of UHF location method 果[1-3]