二遍银粉珍珠喷涂幻灯片.pptVIP

* General information Final flash off and reference to data sheets must be enforced. Instructors script During the final flash off time the clear coat can be mixed with the relevant hardener and thinner combination, typically, fast hardeners and thinners are used for part panel repairs. The gun can be filled after it has been cleaned and placed in the booth ready for use. * General information Novices should be informed of why the final tak cloth wiping should be done. How the clear coat is applied is crucial for overall success. Instructors script Before the clear can be applied, the panel is tak wiped again to remove overspray dust and minor dirt inclusions. The clear coat is applied by spraying outwards from the repair zone, in this scenario the clear coat overspray should be over the wheel arch area and the repair zone will have full gloss. Always follow material data sheets and observe any inter coat flash off times. * General information Blending process and final drying. Instructors script The gun is only flushed through with 2k thinner before the fade out mixture can be put into the gun. This mixture varies between paint manufacturers but it always contains a specially formulated fade out thinner. This is very aggressive and will dissolve the overspray edge and adhere to the original finish, care and control should be observed in its application as overcoating will lead to runs and sags. Infra red drying will cure the coating both effectively and economically, observe manufacturers guidelines when using this type of equipment, as solvent popping and blistering will occur if the lamp is paced too close to the panel. * General information Final polishing can make or break the repair, make sure the trainees understand what happens in the polishing process. Instructors script When the panel has cooled down, it is ready for polishing. The purpose of this is to remove the overspray and make the paint finish appear as if no repair has taken place.