通用塑料气体辅助成型GASWord 文档.docVIP

e Gas Assist Injection Molding Gas A.I.M Seminar 气 体 辅 助 成 型 技 术 2005-02-24 GE Advanced Material Confidential 1 PDF created with FinePrint pdfFactory trial version  e Gas Assist Injection Molding Key Features 主 要 特 征 l An Extension of Traditional Injection Molding 传 统 注 塑 技 术 的 拓 展 l Produces Molded Parts with Hollow Sections 制 品 中 空 l A Low Cavity Pressure Process 低 型 腔 压 力 l A Short Shot Process 缺 料 注 塑 2005-02-24 GE Advanced Material Confidential 2 PDF created with FinePrint pdfFactory trial version  e Gas Assist Injection Molding Molding Overview 成 型 概 述 l High Pressure Gas (Nitrogen) is Injected into the Uncured Resin高 压 气 体 (N 2)充 入 未 凝 树 脂 l The Gas Bubble Follows the Path of Least Resistance (High T Low P)气 体 流 向 阻 力 最 小 处 l Hollow Sections Result from Displaced Resin and Shrinkage in Thick Sections制 品 内 部 壁 厚 处 中 空 2005-02-24 GE Advanced Material Confidential 3 PDF created with FinePrint pdfFactory trial version  e Gas Assist Injection Molding Stages of Gas Assist Molding 气 辅 成 型 的 各 阶 段 部 分 充 模 首 次 充 气 二 次 充 气 2005-02-24 GE Advanced Material Confidential 4 PDF created with FinePrint pdfFactory trial version  e Gas Assist Injection Molding Process Benefits 加 工 优 势 It is important to note that some (not all) of these benefits may be realized for any given part. l Reduced Sink Marks or Read Through under Channels or Ribs减 轻 缩 痕 l Smooth Surface Finish when Compared to Structural Foam制 品 表 面 光 滑 l Reduced Cycle Time when Compared with Structural Foam or Thick Parts降 低 循 环 时 间 l Lower Part Weight in Some Parts减 小 制 品 质 量 2005-02-24 GE Advanced Material Confidential 5 PDF created with FinePrint pdfFactory trial version  e Gas Assist Injection Molding Process Benefits (continued) l Enhanced Flow Capability增 加 流 动 性 ÿ Reduced clamp tonnage requirements降 低 锁 模 吨 位 ÿ Redu