电力电子仿真有限开卷A4参考.docxVIP

一、Matlab函数功能说明1.tf：SYS = TF(NUM,DEN) creates a continuous-time transfer function SYS with numerator NUM and denominator DEN. 2.pzmap：PZMAP(SYS)computes the poles and (transmission) zeros of the dynamic system SYS and plots them in the complex plane.求取系统的零极点3. Margin：Gain and phase margins and crossover frequencies， [Gm,Pm,Wcg,Wcp] = MARGIN(SYS)computes the gain margin Gm, the phase margin Pm, and the associated frequencies Wcg and Wcp。1) bodeBODE Bode frequency response of LTI models.BODE(SYS) draws the Bode plot of the LTI model SYS (created with either TF, ZPK, SS, or FRD). The frequency range and number of points are chosen automatically.2) tf2ss ss2tf[A,B,C,D] = TF2SS(NUM,DEN): Transfer function to state‐space conversion. [NUM,DEN] = SS2TF(A,B,C,D,iu): State‐space to transfer function conversion3）rlocusRLOCUS Evans root locus.RLOCUS(SYS) computes and plots the root locus of the single-input,single-output LTI model SYS. The root locus plot is used to analyze the negative feedback loopand shows the trajectories of the closed-loop poles when the feedback gain K varies from 0 to Inf. RLOCUS automatically generates a set of positive gain values that produce a smooth plot. RLOCUS(SYS,K) uses a user-specified vector K of gain values.4) rlocfindRLOCFIND Find root locus gains for a given set of roots.5) stepSTEP Step response of LTI models. STEP(SYS) plots the step response of the LTI model SYS (created with either TF, ZPK, or SS). For multi-input models, independent step commands are applied to each input channel. The time range and number of points are chosen automatically.6) lsimLSIM Simulate time response of LTI models to arbitrary inputs. LSIM(SYS,U,T) plots the time response of the LTI model SYS to the input signal described by U and T. The time vector T consists of regularly spaced time samples and U is a matrix with as many columns as inputs and whose i-th row specifies the input value at time T(i). For example, t = 0:0.01:5; u = sin(t); lsi