交换机的配置24927 32477.pptVIP

(2) 显示接口命令 使用show interface命令将显示交换机的各网络端口的统计信息。 switch#show interface e0/1 (3) 显示交换机的IP地址 switch#sh ip 7) 管理配置文件（特权模式） （1）备份运行、启动配置 备份运行配置到NVRAM： switch#copy running-config startup-config Destination filename[startup-config]? Building configuration... [OK] 备份到TFTP服务器(CISCO公司的TFTPServer或3COM公司的3Cserver) switch#copy running-config tftp Address or name of remote host[]? Destination filename [switch-config]? .!! (2) 创建软件映像备份 在特权模式下使用copy flash tftp命令，将系统映像文件从路由器拷贝到tftp服务器。 Switch#copy flash tftp Source filename[]?c2500-js-1.120-8.bin Address or name remote host[]?70 Destination filename[c2500-js-1.120-8.bin]? !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!bytes copied int 135.25 secs (3)从网络更新映像 如果现有的映像文件损坏或需要升级到新的版本，就要给交换机加载一个新的系统文件，可以使用copy tftp flash命令。 Switch#copy tftp flash 完 Slide 2 of 2 Purpose: Emphasize: The router has one enable password. Remember that this is your only protection. Whoever owns this password can do anything with the router, so be careful about communicating this password to others. To provide an additional layer of security, particularly for passwords that cross the network or are stored on a TFTP server, you can use either the enable password or enable secret commands. Both commands accomplish the same thing; that is, they allow you to establish an encrypted password that users must enter to access enable mode (the default), or any privilege level you specify. Cisco recommends that you use the enable secret command because it uses an improved encryption algorithm. Use the enable password command only if you boot an older image of the Cisco IOS software, or if you boot older boot ROMs that do not recognize the enable secret command. If you configure the enable secret password, it is used instead of the enable password, not in addition to it. Cisco supports password encryption. Turn on password encryption using the service password-encryption command. Then enter the desired passwords for encry