ITT飞力Steady1300-pumps介绍.pptVIP

高效的电机 飞力潜水电机运行在 ? 载荷时的效率最高。 电机允许在偏离高效点范围内运行。 轴承 检查室 检查室 弹簧环锁定系统 轴 / 叶轮的连接 Spin-Out?专利技术，以避免磨粒在密封腔内积聚 叶轮 降低能耗 降低维护成本 水力 技术 泵是如何工作的 第一步: 后扫式的叶片进口边使得垃圾在此处不会被“勾住”. 第二步: 随着叶轮旋转，垃圾被送至释放凹槽处,而后被推向涡壳泵送出去。 水力端的设计 铸铁叶轮 边缘淬火加硬处理 三通道叶轮 插入环与涡壳用螺栓连接 叶轮间隙通过塞尺测量调节 Guide Pin能够引导缠绕颗粒到不易被缠绕的位置并被泵出 引导叶轮被加工成适合Guide Pin的形状。 被加工的引导叶轮边缘在没有Guide Pin的情况下也有助于防止缠绕。 安装形式 Steady泵1300系列 标准化 P或S型安装，无干式安装 无硬铬叶轮选项 整体式插入环 专用吊环螺丝 标准配置热敏保护开关 F级绝缘电机 标准型Flygt机械密封 标准电缆和Subcab 无冷却夹套和冲洗阀选项 功率50KW 交货期快 应用 污水 冷却水 洪水 原水 污泥 工业污水 N-Hydraulics The challenge has been to make the clog free pump. Historically, the focus has been set on throughlet size; if a large solid enter the sump, the pump must be able to pump it away. This has led to single vane impellers where efficiency is sacrificed to throughlet (and assumed non clog properties). It turned out that the problem in waste water is not large solids. Large solids such as wood blocks, toys, footballs etc are rarely seen in waste water. Instead there is a gradual build-up of particles at the leading edge. Small solids will merge into large ones and thereby cause problems to the pumps. Another clog area in impellers is the impeller neck, so therefor the N impeller is a semi open impeller. To avoid clogging between the impeller and the volute, the volute has a relief groove. Here rags and other solids that get caught between the impeller and the volute are relieved and pumped away. The relief groove is an important part of the N-concept. The last clog area for impellers is the upper clearance between the impeller and the seal housing cover. To eliminate the clog risk in this area, we have made a groove in the impeller and in the cooling bottom, working the same way as the relief groove. Reliable: The two vane semi open impeller with extremely back swept leading edges and the relief groove in the pump housing ensures maximum clog resistance. N-Hydraulics The performance of the N