泓格ViewPAC-2000如何用RS485接串口设备的说明泓格ViewPAC-2000如何用RS485接串口设备的说明.pdf

下载文档 降价啦

2
0
约4.4千字
约 6页
2018-04-26 发布于贵州
举报
版权申诉
保障服务

泓格ViewPAC-2000如何用RS485接串口设备的说明泓格ViewPAC-2000如何用RS485接串口设备的说明.pdf

1、本文档共6页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

泓格ViewPAC-2000如何用RS485接串口设备的说明泓格ViewPAC-2000如何用RS485接串口设备的说明

Classification System and Application FAQ on WinCE PAC No. 1-006-02 Author Tunglu-Yu Version 1.0.0 Date 2010/2/12 Page 1/6 How to link serial devices through RS-485 on VP-2000 Applies to: Platform OS version WinPAC/ViewPAC utility version WP-8x3x N/A N/A WP-8x4x N/A N/A VP-25W1 All versions All versions VP-23W1 All versions All versions . N/A: Not applicable to this platform and OS. The ViewPAC is equipped with one RS-485 COM port (COM2) which enables a transmission rate up to a maximum of 115.2K bps. The twisted-pair, multi-drop, RS-485 network can be used to link i-7000, M-7000, RU-87Pn, high profile I-87K modules and other serial devices. ICP DAS Co., Ltd. Technical document Classification System and Application FAQ on WinCE PAC No. 1-006-02 Author Tunglu-Yu Version 1.0.0 Date 2010/2/12 Page 2/6 MASTER/SLAVES SETTINGS In master/slave applications, “Master” is the default configuration for ViewPAC. Using ViewPAC as a Master (default): When one of the ViewPAC devices is set as the master, then all the other devices on the same network must be set to slave mode. Set a ViewPAC to Master mode by adjusting the jumpers on the power board for ViewPAC (the pull-high/pull-low resistors are set to enabled). Refer to the following figure: ICP DAS Co., Ltd. Technical document Classification System and Application FAQ on WinCE PAC