把手振动量测系统之建立及其在农用动力式手工具之应用.pdfVIP

9 3 2000 9 23 農業機械學刊 第 卷 第 期 年 月 把手振動量測系統之建立及其在農用 動力式手工具之應用 1 2 詹聚法 ，葉仲基 1. 國立臺灣大學農業機械工程學研究所碩士 2. 國立臺灣大學農業機械工程學系副教授，本文通訊作者 摘 要 把手振動之量測系統是由手脕換能器組、電荷放大器、記錄器、訊號分析儀 等儀器設備及一套分析控制軟體所組合而成的。手脕換能器組是安裝在動力式手 工機具的把手上，記錄器及電荷放大器則安裝在手拉式台車上，以記錄把手之振 動情形。於實驗室內，將記錄器所錄之訊號再度播放，經訊號分析儀進行 1/n 倍 頻分析。使用分析控制軟體(BK 3550 WINDOWS PROGRAM)將振動資料轉換成 ASCII 碼資料，進行數據處理及統計分析工作。 將分析結果與 ISO 5349 作比較，發現電鑽、研磨機及割草機在中央頻率 6.3~1250Hz 內之把手振動量，均未超過ISO建議之振動暴露極限值。 關鍵詞 ：電鑽、研磨機、割草機、把手振動、暴露限值 DEVELOPMENT OF A MEASUREMENT SYSTEM FOR HANDLE VIBRATION AND ITS APPLICATION TO THE AGRICULTURAL POWER HAND TOOLS AND MACHINES 1 2 Chu-Fa Chan , Chung-Kee Yeh 1. Former Graduate Student, Department of Agricultural Machinery Engineering, National Taiwan University. 2. Associate Professor, Department of Agricultural Machinery Engineering, National Taiwan University, Corresponding Author. ABSTRACT The measurement system of handle vibration is consist of a hand-arm vibration set, a charge amplifier, a recorder, a signal analyzer and a computer software. The hand-arm vibration set, the recorder and the charge amplifier were installed on the handle and trolley respectively to record the handle vibration. After experiments were finished outdoors, the recorder could replay the signal and transfer them into the signal analyzer to execute the 1/n-octave analysis in the laboratory. The computer software BK 3550 WINDOW