NOVELL SUSE NCLP 3103课程6.pptVIP

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Setting an IPv6 Address Using YaST Setting an IPv6 Address Using YaST (continued) Setting an IPv6 Address Using YaST (continued) After installation, you can reach the same dialogs by selecting Computer YaST Network Devices Network Settings. The settings are written to the /etc/sysconfig/network/ifcfg-ethx file, as shown below: BOOTPROTO=static BROADCAST= ETHTOOL_OPTIONS= IPADDR=fd7b:5c7e:40bf:1234::2/64 MTU= NAME=82566DM Gigabit Network Connection NETWORK= REMOTE_IPADDR= STARTMODE=auto USERCONTROL=no NETMASK= Managing IPv6 Addresses Using the Command Line Tools Use the following command to add an IPv6 address: The current configuration is displayed using the ip address show command. Adding the option -6 limits the output to IPv6 addresses: da10:~ # ip -6 addr add fd7b:5c7e:40bf:1234::2/64 dev eth0 da10:~ # ip -6 a s 2: eth0: BROADCAST,MULTICAST,UP,LOWER_UP mtu 1500 qlen 100 inet6 fd7b:5c7e:40bf:1234::2/64 scope global valid_lft forever preferred_lft forever inet6 fe80::219:d1ff:fe9f:17f4/64 scope link valid_lft forever preferred_lft forever Managing IPv6 Addresses Using the Command Line Tools (continued) To delete an address, use ip address delete: The ip command is also used to view, set, and delete routes. ip -6 route show displays the current routing table: da10:~ # ip -6 add del fd7b:5c7e:40bf:1234::2/64 dev eth0 da10:~ # ip -6 ro sh dev eth0 fd7b:5c7e:40bf:1234::/64 proto kernel metric 256 mtu 1500 advmss 1440 hoplimit 4294967295 fe80::/64 proto kernel metric 256 mtu 1500 advmss 1440 hoplimit 4294967295 Connecting to Other IPv6 Addresses If you get an IPv4 address only, there are two possible approaches to connect to IPv6 addresses: 6to4-Tunneling 6in4-Tunneling 6to4-Tunneling A site with a globally unique IPv4 address can be assigned a globally unique IPv6 address based on its IPv4 address. IPv6 addresses used for this purpose have the following format